GB/T19672-2005 is a historical edition. GB/T19672-2021 took effect on October 1, 2021 and replaced it. A project must identify the applicable edition and contract requirements; the historical clauses below are not a substitute for the current project specification.
GB/T19672-2005 addressed pipeline valves, with references to the historical ISO14313:1999 and API6D:2002 editions. This standard specifies the terminology, structural types and parameters, ordering requirements, technical requirements, materials, inspection rules, test methods, markings, etc. of gate valves, ball valves, check valves, and plug valves with flange connections and welded connections. Suitable for natural gas and oil pipelines with nominal pressures ranging from PN16 to PN420 and nominal diameters ranging from DN15 to DN1200, including gate valves, ball valves, check valves, and plug valves.
Historical comparison of GB/T19672-2005 with the cited ISO14313:1999 and API6D:2002 editions:
(1) The standard format follows the requirements of GB/T1.1-2000, which is different from ISO/API standards.
(2) Adopt some terms and definitions from the standard.
(3) Added nominal pressure PN16 PN25、PN40。
(4) The order requires content modification.
(5) Increased the structural length of ball valves larger than DN1000.
(6) Added requirements for the threads of the connecting bolts of the valve housing.
(7) Welding and inspection requirements shall be stipulated in accordance with the requirements of Chinese laws and regulations.
(8) Established inspection rules for valves.
Technical topics in the historical GB/T19672-2005 discussion:
(1) Terminology
Terminology distinguishes nominal size from actual bore, full-bore from reduced-bore configurations, and the permitted pressure or sealing directions. One-way and bidirectional capability concern the specified pressure or sealing duty; they do not describe the number of pipeline ports. Locking provisions are another separate feature.
(2) Structure
The structural discussion covers gate, ball, plug and check valves and their connection arrangements for pipeline service.
(3) Pressure and temperature rating
Pressure–temperature selection must address the actual valve material and construction as well as the connected flanges. GB/T9131-1988 was a historical flange reference, later replaced within the flange standards system; it is not a universal material specification for every valve body. The rating of the complete assembly also depends on seals, fastening and the applicable design requirements.
(4) Structural length
A matching face-to-face dimension is only one condition for replacement. The selected table and edition, end connections, pressure class, materials, sealing direction, actuator space and service conditions must also correspond. Valves are not automatically interchangeable merely because both cite API6D. A mixed welded-and-flanged arrangement requires its own end-to-end drawing.
(5) Representation of diameter
Specify nominal size and actual bore separately. DN or NPS identifies a nominal size, not a measured passage diameter. The selected bore and transition arrangement must suit the pipeline, pressure loss and any pigging requirement; a common nominal size alone does not prove identical internal geometry.
(6) Minimum bore and passage shape
For a pipeline that will be pigged, identify the minimum clear passage and the internal shape along the complete route. Steps, seats and changes of section can affect passage. Apply the requirements of the selected standard edition and actual pigging design rather than infer compatibility from the nominal size alone.
(7) Structural requirements
It specifies the structures that affect the performance of valves in long-distance pipelines and have operational requirements. It specifies the operating torque and performance requirements for pipeline valves.
(8) Material
Material selection addresses the body and other relevant parts, corrosion protection, sour-service conditions where applicable, welding and repair welding. Hardness is one part of a material assessment, not a stand-alone certificate of suitability for every sulfur-containing medium.