Skip to main content
Trekre - Industrial valves
qiang@tekron.com.cn +86 510 88232303
Trekre

Industrial Valve Manufacturer

Enquiry

Double-Acting Rack-and-Pinion Pneumatic Actuator

Double-Acting Rack-and-Pinion Pneumatic Actuator

Product parameters

Application and package scope

Compressed air drives the piston racks, turning the output pinion through a partial rotation. Both opening and closing require air supply. The actuator can operate ball valves, butterfly valves and other compatible valves after matching the load and control circuit.

Configuration options and purchasing checks

ItemConfiguration
Drive mechanismPistons, racks and output pinion
ActionDouble-acting; air-driven in both directions
Rotation referenceTypically 90°; check the actual travel for the selected model
Air-supply referenceTypically 0.4~0.7MPa; maximum permissible supply pressure per model nameplate
Operating timeDepends on model, load, air supply and pneumatic accessories
Accessory optionsSolenoid valve, end-position feedback, filter regulator, speed control and position-holding arrangement

Check torque at the minimum available air pressure

The minimum site pressure may be lower than the air-station setting. Compare actuator torque with the valve operating load at the pressure available at the actuator inlet. Also check the flow capacity of the tubing and solenoid valve.

Air-failure behaviour depends on the complete circuit

A double-acting actuator does not inherently provide spring return. Valve load and residual pressure can affect its position after air failure. Do not assume fail-close or position holding; specify and validate the appropriate pneumatic circuit if holding position is required.

Check mechanical interfaces and accessories separately

Match the output shaft, mounting flange, coupling and rotation direction to the valve. The solenoid valve switches air paths, limit switches report end positions, and a positioner controls position. These accessories perform different functions and cannot substitute for one another.

Enquiry and supply documents

Provide the mating valve, load or service conditions, interface drawing, utility and control requirements, environment and quantity. Jiangsu Tekron Flow Control Valve Co., Ltd. can discuss a suitable configuration on this basis. The final model, accessories, drawings and inspection requirements are subject to the agreed technical specification.

Product photographs illustrate a configuration; not every accessory shown is automatically included in the supply.

Related categories:Valve actuators and accessories · Electric actuated valves · Pneumatic valves · Control valves

Selection questions

Does a double-acting actuator always stay in position after air failure?

No. Its final position depends on the load, air circuit and accessories. Define any position-holding requirement and provide an appropriate circuit.

Should selection use compressor discharge pressure or actuator inlet pressure?

Use the minimum available pressure at the actuator inlet, allowing for pressure losses in tubing, solenoid valves and simultaneous operation.

Are solenoid valves and limit switches included as standard?

Not automatically. Specify the accessory quantities, models, voltages, feedback types and mounting hardware in the supply list.

Discuss your valve configuration and quotation

For overseas project enquiries: Trekre.

Complete the details you know; leave unknown operating conditions blank. Name, email and enquiry are required. Phone is optional.

Add operating and connection requirements (optional)

Include units. PN and ASME Class are separate designations, not a fixed conversion.

Email drawings, nameplate photos or technical files with the product link. This form does not accept attachments. [email protected]