Skip to main content
Trekre - Industrial valves
qiang@tekron.com.cn +86 510 88232303
Trekre

Industrial Valve Manufacturer

Enquiry

On/Off Part-Turn Electric Actuator

On/Off Part-Turn Electric Actuator

Product parameters

Application and package scope

For remote on/off operation of ball valves, butterfly valves and other part-turn valves. A reduction gear transmits motor output to the valve stem. Select for the valve operating load, required rotation and site power supply, for circuits requiring fully open, fully closed and end-position feedback.

Configuration options and purchasing checks

ItemConfiguration
MotionPart-turn, typically approximately 90°; actual rotation per valve and actuator data
Control dutyOn/off isolation; not supplied as a continuous-modulating version
Power-supply optionsAC220V or AC380V; select any DC24V option for the specific series
FeedbackOpen and closed end positions; contacts and wiring per configuration list
Local operationManual mechanism and mode changeover per selected version
Selection basisBreakaway, running and closing torque, and the valve's allowable input load

Match output to the valve load

Breakaway, running and final seating torques may differ and must each be checked against the valve data. The actuator must complete the required movement without exceeding the allowable loads of the stem, coupling or seat. Equal valve sizes do not establish that the same actuator size is suitable.

Specify power and control interfaces separately

Motor power, on/off commands and feedback contacts are separate interfaces. State voltage, frequency, control-cabinet command type, feedback requirements and operating frequency separately. A voltage alone does not define the control requirements.

Replacement interfaces and power failure

For replacement, check the mounting flange, output bore, coupling, travel and rotation direction. Do not assume that a conventional on/off actuator returns on power failure. If movement after power loss is required, specify energy storage, backup power or another failure-response arrangement separately.

Enquiry and supply documents

Provide the mating valve, load or service conditions, interface drawing, utility and control requirements, environment and quantity. Jiangsu Tekron Flow Control Valve Co., Ltd. can discuss a suitable configuration on this basis. The final model, accessories, drawings and inspection requirements are subject to the agreed technical specification.

Product photographs illustrate a configuration; not every accessory shown is automatically included in the supply.

Related categories:Valve actuators and accessories · Electric actuated valves · Pneumatic valves · Control valves

Selection questions

Can an open-position signal prove that the valve is shut tight?

No. An end-position signal reports actuator position. Seat tightness still requires testing of the complete valve under the agreed conditions.

Can a ball valve and butterfly valve of the same size use the same actuator?

Not on size alone. Check the load, rotation, interface and allowable input load of each valve before deciding whether one actuator size is suitable.

Should an enquiry state both power and control voltages?

Yes. List motor power, control commands and feedback contacts separately, and use the wiring diagram for the selected actuator.

Discuss your valve configuration and quotation

For overseas project enquiries: Trekre.

Complete the details you know; leave unknown operating conditions blank. Name, email and enquiry are required. Phone is optional.

Add operating and connection requirements (optional)

Include units. PN and ASME Class are separate designations, not a fixed conversion.

Email drawings, nameplate photos or technical files with the product link. This form does not accept attachments. [email protected]