Application and package scope
Combines setpoint input, position sensing and motor drive for remote position control of multi-turn valves. Check turns per stroke, modulating load and the I/O schedule together. An analogue interface alone does not establish that the complete valve is suitable for continuous modulation.
Configuration options and purchasing checks
| Item | Configuration |
|---|---|
| Output motion | Multi-turn |
| Control duty | Valve-position control according to configuration |
| Typical setpoint | 4–20mA; signal direction and range per project requirements |
| Position feedback | Continuous position output per selected module |
| Power-supply reference | AC220V or AC380V |
| Mechanical matching | Output torque, speed, turns, stem connection and thrust interface |
Define the valve's process duty first
An actuator's ability to receive intermediate-position commands does not change the valve's throttling suitability. Isolation gate valves and purpose-designed control trim have different flow characteristics, allowable differential pressures and erosion limits, which must be checked separately.
Calibrate setpoint and feedback consistently
Define the full-stroke endpoints, movement direction and relationship between setpoint and feedback. Commissioning records must correspond to actual stem travel. A control-room percentage display alone does not prove mechanical end position or acceptable sealing.
Specify frequent operation in the purchasing requirements
Modulating torque, operating frequency, normal positions and motor duty influence selection. Where abnormal-state action is required, specify the response to power loss, signal loss and faults separately, and check the hardware and configuration needed to implement it.
Enquiry and supply documents
Provide the mating valve, load or service conditions, interface drawing, utility and control requirements, environment and quantity. Jiangsu Tekron Flow Control Valve Co., Ltd. can discuss a suitable configuration on this basis. The final model, accessories, drawings and inspection requirements are subject to the agreed technical specification.
Product photographs illustrate a configuration; not every accessory shown is automatically included in the supply.
Related categories:Valve actuators and accessories · Electric actuated valves · Pneumatic valves · Control valves
Selection questions
Does a smart actuator turn an ordinary isolation gate valve into a control valve?
No. First establish that the valve trim, allowable differential pressure and operating mode are suitable for continuous throttling, then select the modulating actuator.
Must position feedback be adjusted if the turns per stroke change?
Recheck travel and signal calibration according to the assembly instructions so that actual valve position, travel limits and feedback remain consistent.
Which original documents should be retained for a smart multi-turn replacement?
Retain the nameplate, interface and stem dimensions, full-stroke turns, wiring diagram and I/O schedule, and check the existing fault-response logic.